Siirry sisältöön

Hakutulokset

Hakutulokset

Haulla "282" löytyi 133 tulosta.

SFS-EN 2824 – Aerospace series. Burning behaviour of non-metallic materials under the influence of radiating heat and flames. Determination of smoke density and gas components in the smoke of materials. Test equipment apparatus and media

Verkkokaupan tuotteet
This standard defines the test equipment, apparatus and media required for determination of the smoke density according to EN 2825 and the concentration of the gas components in the smoke according to EN 2826 due to pyrolitic decomposition of solid materials and composite materials of up to 25 mm ...
https://sales.sfs.fi/julkaisu.html.stx?id=894017

SFS-EN ISO 22282-6:en – Geotekninen tutkimus ja koestus. Geohydrauliset kokeet. Osa 6: Porareiässä suljetussa tilassa tehtävät vedenläpäisykokeet

Verkkokaupan tuotteet
ISO 22282-6:2012 specifies requirements for the determination of the local permeability in soils and rocks below or above the groundwater table in a closed system by the water permeability tests as part of the geotechnical investigation services according to EN 1997-1 and EN 1997-2. The standar ...
https://sales.sfs.fi/julkaisu.html.stx?id=203478

SFS-EN ISO 22282-2:en – Geotekninen tutkimus ja koestus. Geohydrauliset kokeet. Osa 2: Porareiässä avoimessa tilassa tehtävät vedenläpäisykokeet

Verkkokaupan tuotteet
ISO 22282-2:2012 specifies requirements for the determination of the local permeability in soils and rocks below and above groundwater level in an open hole by water permeability tests as part of the geotechnical investigation services according to EN 1997-1 and EN 1997-2. The standards writing ...
https://sales.sfs.fi/julkaisu.html.stx?id=203481

SFS-EN ISO 16282:en – Methods of test for dense shaped refractory products. Determination of resistance to abrasion at ambient temperature (ISO 16282:2007)

Verkkokaupan tuotteet
ISO 16282:2007 specifies a method intended primarily for the determination of the abrasion resistance of shaped refractory materials at ambient temperature. It can also be used for unshaped refractory materials. It provides an indication of the suitability of the material for service in abrasive ...
https://sales.sfs.fi/julkaisu.html.stx?id=112134

SFS-EN 60684-3-282:en – Flexible insulating sleeving – Part 3: Specifications for individual types of sleeving – Sheet 282: Heat-shrinkable, polyolefin sleeving – Stress control

Verkkokaupan tuotteet
IEC 60684-3-282:2010 gives the requirements for two types of heat-shrinkable, polyolefin sleeving, stress control, not flame retarded, with a nominal shrink ratio up to 3:1. This sleeving has been found suitable for use up to temperatures of 100 °C. - Type A: Medium wall - Internal diameter up ...
https://sales.sfs.fi/julkaisu.html.stx?id=333600